New
+
Horsepower
+
Newton meter
CSF Radiators

CSF BMW Gen 1 B58 Charge-Air-Cooler Manifold - Machined Billet Aluminum

Article nr:
csf8300
|
The CSF #8300 Cooling product is designed to be a ""Drop-In Fit"" application. The product will install in the OEM Location with no modifications necessary unless otherwise noted or instructions are included in the product package. Please see the manufacturer repair manual for standard installation instructions. If you do not feel confident installing this product CSF recommends taking it to a qualified installation facility.
 
5114 EUR
Add to cart
Delivery:  2-4 business days
Sales Representative Image

Talk to an expert

Need help? Check fitment, get personalized recommendations and tips.

Contact us

  • Product description
  • Air Inlet Divider: The inclusion of an air divider welded into the inlet side tank of the manifold is another exclusive feature of the CSF manifold. With the length of the manifold, the engineers at VF Engineering wanted to make sure that the volume and velocity of air was consistent to all cylinders. After extensive simulations in SolidWorks CFD software, an air divider was added to the design to ensure the best possible and equal cooling performance to each cylinder of the engine. Airflow to the back of the manifold (cylinders four, five, and six) should be equal to the airflow to the front of the manifold (cylinders one, two, and three) for the best possible performance.

    Product video

    Technical specification

    Article nr:
    csf8300
    Manufacture Partnumber: 8300
  • Suitable for
  • Brand
  • CSF Radiators

    CSF manufactures the most efficient and advanced cell packs for coolers in the entire industry. It is a status gained through its innovative Tube & Fin-Technology and market-leading tests in terms of cooling and flow. These technologies have made it possible for CSF to develop cooler technology throughout the market.

    B-Tube Technology

    Normally, O-shaped fluid channels are used. CSF, on the other hand, uses channels shaped like a B. These B-shaped tubes are very carefully shaped and then soldered together at the seam. This allows the CSF to use a thinner and lighter aluminum (which gives a better cooling effect) because the shaping makes the material stronger than when using the traditional O-shape.

    This type of design on the channels increases the surface where the heat exchanges occur with approx. 15% compared to the old technology!

    Highly efficient flanges

    CSF uses flanges with several ventilations that are carefully lined up to maximize airflow through the cell pack. Each model of cooler is special and each specification is carefully measured and calculated and then tested in CSF's wind tunnel for the best possible cooling effect.

  • Accessories & Spare Parts
  • Guarantee

Reviews and questions

Last viewed products

Recommended for you

Login / Retailer
Enter your username and password below:
Username
Password
Choose country